How do I reset my Honda SRS light?
How do I reset my Honda SRS light?
Reset Your SRS Light
- There is a yellow plug under the dash plugged into the fuse panel.
- Turn the ignition key to the “ON” (II) position.
- When the SRS light comes back on plug the jumper wire back in within 4 seconds the light will blink twice and go out.
- Unplug the jumper and turn the ignition key off.
How do you reset the airbag light on a Honda CRV?
How do you reset the airbag light on a Honda?
- Turn IGNITION on (but don’t start car)
- After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.
- Wait 4 seconds.
- Turn IGNITION on (but don’t start car)
- After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.
What does SRS mean on a 2002 Honda CRV?
Supplemental Restraint System (SRS) Warning Light On.
Why is my Honda CRV SRS light on?
If your Honda airbag light remains on, it most likely means that the Supplemental Restraint System (SRS) has detected a problem with the airbag system. When your Honda airbag system functions properly, the airbag light comes on when you turn on the ignition but should turn off once you start the engine.
What can cause SRS light to come on?
If the SRS light stays on or starts flashing on and off, you may have a problem with the airbags themselves, a loose wire, a faulty seat belt buckle, or a problem with the Engine Control Unit (ECU) that is causing the airbag warning light to stay on.
Where is the reset button on honda crv?
Press and hold the Select/Reset button on the dashboard instrument panel. The Select Reset button is located between the E on the fuel gage and the odometer.
How do you clear the code on a honda crv?
To reset the check engine light in your honda crv turn the key to the “on” position and depress the reset button and select “yes” to clear.
How do you turn off the SRS light on a Honda CRV?
Strip the ends of both wires using a knife. Keep the ends of the wire touching while you do this. Repeat Step 3 and the SRS light will blink twice and turn off. Unshort the two wires. This will cause the SRS light to blink twice.
Is there a way to reset the SRS light?
Having the SRS light come on is so common that the original owner’s manual actually gives a briefing on how to reset it. To do so, you will be “shorting” the system in order to reset the light. Locate the MES (Memory Erase Signal) connector.
What does SRS stand for in Honda Civic?
Learn how to do so here. This article applies to the Honda Accord (1990-2002) and Honda Civic/Del Sol (1992-2000). The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things.
Why does my Honda SRS light keep blinking?
The SRS light will blink twice indicating the SRS system and the light are reset. If this procedure is followed correctly and the light remains on, then there may be an actual issue with the SRS system. In this case, it is advised to bring the vehicle to the dealership, where the trouble code can be identified and the issue repaired.