How do I reset my EZ Go golf cart?

July 22, 2020 Off By idswater

How do I reset my EZ Go golf cart?

Where is the reset button on a golf cart? It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again.

How do you put a ezgo golf cart in diagnostic mode?

To enter diagnostics mode turn the key switch to off, move the run/tow switch to run, move the direction switch from neutral to rev 5 times. The cart will beep to confirm you are in diagnostics mode. After that, the diagnostics code beep will sound if there is a problem.

Does a EZGO golf cart have a reset button?

Go to the back of the golf cart and find the panel that covers the electric motor. Four or six screws will hold the panel in place. Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.

How do I troubleshoot my EZGO golf cart?

Things to Keep in Mind Before Troubleshooting

EZGO golf cart batteries aren’t perfect right away.
Sticky accelerators are perfectly normal and can be fixed easily.
Keep your cart stable.
Make sure your charging wall socket isn’t faulty.
Keep your tire pressure stable.
Troubleshooting the speed controller.

Why does my ezgo golf cart beep?

Any EZGO that beeps while driving indicates that the battery is faulty. A faulty golf cart battery leads to a low voltage fault code getting signaled. If the problem persists, one should check each of the batteries. Properly charging the batteries can certainly fix the issue.

How do I test my EZ GO speed sensor?

The EZGO speed sensor can be tested by ensuring that the three-pin plug from the sensor is connected.

Keep a wire-piercing probe over the output wire. This is usually green in color.
Raise one of the wheels of the EZGO golf cart and give it one full rotation using your hand.
Note the voltage reading of the cart.

How do you reset the OBC on a golf cart?

Resetting the OBC must be performed in this order:

Key switch to off.
Set forward/reverse to neutral.
Put tow/run switch to tow.
Disconnect the negative battery terminal from the battery pack.
Put the tow/run switch to run.
Put forward/reverse switch to reverse.
Put key switch to on.

How to troubleshoot the EZGO golf cart controller?

Follow these steps to troubleshoot the controller of an EZGO: When the cart is to be serviced or the controller needs troubleshooting, the maintenance switch under the seat needs to be flipped. Flip the switch and turn the tow maintenance mode on. Now, take the negative battery cable (black) and disconnect it.

How to reset my club car golf cart OBC?

Easily Reset the Club Car Golf Cart OBC 1 Reconnecting the OBC into the system: 2 Key switch to off 3 Set forward/reverse switch to neutral 4 Put tow/run switch to tow 5 Reconnect the negative battery terminal from the battery pack

Where is the maintenance switch on an EZ GO speed controller?

All EZ-GO speed controllers are equipped with a maintenance switch that needs to be flipped before you begin work on repairing the problem. You will likely find the switch under the seat of your golf car,t but if you’re having trouble finding it, consult your owner’s manual.

What causes a golf cart controller to reset?

If you disconnect the controller from the golf cart will cause a soft reset of the of the OBC when the battery power is removed. Once the battery powered is removed, the OBC internals will clear any faults. Once the controller is reinstalled, everything should work fine.

What kind of speed controller does an EZ GO have?

Every EZ-GO golf cart comes equipped with one of two kinds of speed controllers, a precision drive system or a drive control system. All modern golf carts (Including any cart that is sold by Garrett’s) use the precision drive system or PDS, whereas older carts made before 1994 will use a drive control system.

CategoryPopular lifehacks